|
Post by jwaldrip on Jan 2, 2009 23:52:57 GMT -5
is ertls 9610 casting too big for a 9510? im assuming it is
|
|
|
Post by 70ds on Jan 2, 2009 23:59:09 GMT -5
I think it is too wide.
|
|
|
Post by Chris Taylor on Jan 3, 2009 0:08:50 GMT -5
But it would work fine. I plan to just cut the whole ting in two when I do mine. then grind off on each side as much needed.
|
|
|
Post by rysiracusa on Jan 3, 2009 9:53:40 GMT -5
You may have to make minor adjustments
|
|
|
Post by 774630 on Jan 4, 2009 23:34:09 GMT -5
the 95s were all a 50inch cylinder and the 96s are 60inch. so I believe the 95s were 10 inches narrower. Not much of a differance, I dont think anyone would really notice unless they actually measured the thing.
|
|
|
Post by jwaldrip on Jan 5, 2009 22:30:23 GMT -5
the 95s were all a 50inch cylinder and the 96s are 60inch. so I believe the 95s were 10 inches narrower. Not much of a differance, I dont think anyone would really notice unless they actually measured the thing. thanks alot. thall work for me. shh dont tell any judges if i ever show it. ;D
|
|