|
|
Post by ontariofarms on Jan 31, 2016 13:38:51 GMT -5
This is my first post on here so please go easy, anyhow I am customizing a case ih magnum 215 with floatation duals but want to make the duals removable. Is there any tricks or tips that anyone knows of?
Thanks
|
|
|
|
Post by ramman00 on Jan 31, 2016 13:48:02 GMT -5
Well ive done a couple. What I do is drill out the rivet on one side carefully not to drill into the actual rim. I then trim both sides of the current axle or install a new one to the correct length, make sure the axle is even on both sides then glue the inside tires on, make sure the glue doesn't spread to the hole the axke sits in. Wait for the glue to dry then slip on the outside duals and they should come on and off pretty easy. Also make sure your treads are pointing in the right direction. Hope it helps!
-Tyler
|
|
|
|
Post by ontariofarms on Jan 31, 2016 15:52:10 GMT -5
Well ive done a couple. What I do is drill out the rivet on one side carefully not to drill into the actual rim. I then trim both sides of the current axle or install a new one to the correct length, make sure the axle is even on both sides then glue the inside tires on, make sure the glue doesn't spread to the hole the axke sits in. Wait for the glue to dry then slip on the outside duals and they should come on and off pretty easy. Also make sure your treads are pointing in the right direction. Hope it helps! -Tyler Thank you for the help it's very muh appreciated |
|
|
|
Post by nemueller17286 on Jan 31, 2016 19:16:30 GMT -5
If you want to add some extra detail you can use something for a hub when the duals are off. I think Moore's makes them but you could use pretty much anything that is round and would slide on the axle.
|
|
